2002 Harley-davidson Fxdwg Dyna Wide Glide How Do You Check Oil?

How do you check the oil on a Dyna Wide Glide?

The transmission oil is checked with the motorcycle on a level surface and on the kickstand. Wipe off the dipstick/fill plug and thread it into the transmission case until the o-ring lightly contacts the case, but do not tighten. Now, remove the dipstick/fill plug and view the oil level.

What happens if I put too much oil in my Harley?

Adding too much oil to a motorcycle will increase the pressure in the crankcase which in turn forces oil out of the engine and into your intake system. This can cause damage to the engine as well as burn oil in the engine where oil is not supposed to be present. Too much oil or too little oil will damage components.

How often should I check my oil on my Harley Davidson?

A: NO, the service interval does not change for engine oil with Syn3. Harley-Davidson® recommends that your motorcycle receive servicing at least every five thousand miles, depending upon rider, riding style and conditions. Sometimes more frequent oil changes can be warranted.

You might be interested:  Readers ask: Why Does My Harley Davidson Golf Cart Run Great In Reverse And Bad In Forward?

Do Harley Davidsons burn oil?

Harleys are dry-sump bikes, meaning the oil is stored remotely and pumped in. All older Harleys and some new ones locate the oil in a tank that is higher than the bottom of the engine cases. Thus, the oil blows out the crankcase breather or air cleaner in copious amounts.

What kind of oil do you put in a Harley Davidson transmission?

Heavy Synthetic Gear Oil. TESTED-CERTIFIED for use in Harley-Davidson transmission and primary chaincase applications.

Do you check motorcycle oil on kickstand?

You can’t get a good reading if your bike’s on its kickstand, so grab a buddy to hold it up for you, invest in a stand or apply the brakes while gently balancing it on its wheels. This isn’t a job for a hot bike. Your dipstick and sight glass are designed for cool oil, which doesn’t have the same viscosity as hot oil.

Do you check Harley oil hot or cold?

Oil quantity is only 3- 3.5 qts or so it wont expand a lot there is a range on the stick so hot /cold whatever if it is hot just let it sit a few minutes after shutting the engine off before checking the level. Keep it in the range listed on your stick.

How much oil does an 88 cubic inch Harley take?

Fluid capacity is 1 Quart * (32 fluid oz) for all Evo and Twin Cam88/103 primaries from 1980-2006 (*except 2006 Dyna). The new bikes 2006-up Dyna, 2007-up Softail & Touring take a 45 fluid oz if the entire primary assembly has been removed or 38 fluid oz if you are simply draining the old fluid adding new oil.

You might be interested:  Question: What Are The Pros And Cons Of A Harley Davidson Motorcycles?

Should I check my motorcycle oil hot or cold?

You should check engine oil when the engine is warm because a warm engine indicates that it has been running for a while – allowing the engine oil to fully circulate around and give you a more accurate reading. It’s also important to allow the engine to stop for a minute before you perform the engine oil check.

What type of oil goes in a Harley primary?

You actually have a couple of choices for the primary drive. The optimum product would be Mobil 1 Racing™ 4T 10W-40 motorcycle oil, but it is also okay to use Mobil 1™ V-Twin 20W-50.

When should I use 20W50 oil?

20W50 motor oil is suitable for warmer climates, where the higher temperature causes the oil to thin. It is also useful for vehicles subject to hot temperatures and for those used for high-stress activities such as hauling or pulling trailers.

How much oil goes in a Harley transmission?

The transmission fluid capacity is approximately 24 ounces (0.71 liters).

Leave a Reply

Your email address will not be published. Required fields are marked *