How Do You Clear The Code On A Harley Davidson?

How do I manually clear a code?

Use a Code Scanner Turn your ignition switch to “On.” Turn off all accessories. Press the “Read” button on your scan tool to view the engine’s error codes. Remember the code or codes in the order they were received for future repairs if necessary. Press the “Erase” button on your scanner to clear the error code.

How do I reset my Harley Davidson?

Harley Davidson Touring: How to Reset Your ECM

  1. Step 1 – Turn run switch on. Before you start the reset procedure, be sure your run/stop switch is turned on.
  2. Step 2 – Turn ignition on and off. With the run/stop switch on, turn the ignition on and then off three times.
  3. Step 3 – Turn run switch off.

How do you enter Harley Davidson codes?

To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. If there are any DTC’s the code will be displayed or the word “none” will appear if there are no DTC’s. Push the odometer reset button again to view additional codes if they exist.

You might be interested:  Often asked: What Industry Is Harley Davidson In?

What is the code to reset your phone?

*2767*3855# – Factory Reset (wipe your data, custom settings, and apps). *2767*2878# – Refresh your device (keeps your data).

How do you reset the limp mode on a Harley?

Turn Ignition switch to OFF & Run/Stop switch is to Run. Push odometer reset button in & hold. Turn ignition switch to Ignition and release odometer reset button.

How do you reset the service due on a Harley Davidson?

e-Press and hold the power/mute button until the service menu is displayed. 2-Select: Reset. 3-Select: Mileage Reset. 4-Select: Confirms mileage reset.

How do I reset my Harley speedometer?

To reset the trip-odometer to zero, press button to reset speedometer display to the ODOMETER mode and hold the button in for approximately 2 to 3 seconds. The speedometer will switch to the trip-odometer mode and reset the display to zero.

What is the red key light on my Harley?

The red “key” light is telling you that the security system is operational. The fact that it goes out after you start it up means that the security system is disarmed.

What does the red light on a Harley speedometer mean?

With the Ignition switch off, put the bike into the “run” position, then turn on the ignition. This should put your bike into diagnostics mode. Use the “Trip” switch to cycle through the codes. anyway.that red light means check your codes!

What is this code * * 4636 * *?

If you would like to know who accessed Apps from your phone even though the apps are closed from the screen, then from your phone dialer just dial *#*#4636#*#* it will show up results like Phone Information, Battery Information, Usage Statistics, Wi-fi Information.

You might be interested:  Readers ask: What Would Cause My 2000 Harley Davidson 883 Sportster Smell Like Gas Not Start?

What does ## 72786 do?

Open your native dialer (the one that was built-in when you purchased the device) as opposed to your TextNow dialer. Enter the code ##72786# (your code might be different so see the chart below). The phone will reboot a couple of times as it resets your network connection and information.

What happens if you dial *# 06?

Display your IMEI: *#06# The IMEI is unique to your device. Among other things, the number can help “blacklist” stolen devices or help with customer support.

Leave a Reply

Your email address will not be published. Required fields are marked *