Often asked: What Has To Be Done To Replace The Throttle By Wire On A 08 Harley Davidson?
- 1 What year did Harley go to throttle by wire?
- 2 Why does my Harley have 2 throttle cables?
- 3 What does the idle cable do on a Harley?
- 4 How much does it cost to replace a throttle cable?
- 5 Are throttle cables universal?
- 6 Is my Harley Davidson throttle by wire?
- 7 What causes a Harley to go into limp mode?
- 8 What does TBW mean on a Harley Davidson?
- 9 Is throttle cable and accelerator cable the same?
What year did Harley go to throttle by wire?
In 2008 Harley-Davidson introduced a new throttle system called Electronic Throttle Control (ETC), which eliminates the throttle cables connecting the throttle and the throttle body and replaces them with an electronic connection. ETC is standard on all 2008 and 2009 touring models, including CVO touring models.
Why does my Harley have 2 throttle cables?
A push/pull throttle cable is an upgrade to the old standard single throttle cable linkage. The throttle grip works on the carburettors when twisting/throttling up and when releasing/throttling down. The second cable pulls the carb closed so it isn’t stuck wide open.
What does the idle cable do on a Harley?
Premium Member. The spring on the end of the Throttle return (idle) cable is a safety feature designed to prevent you from jamming the throttle actuator back into the closed position. It also allows for the change in cable sleeve geometry when you turn the handlebars.
How much does it cost to replace a throttle cable?
A throttle cable replacement usually costs around $50 to $100. To ensure that you’re getting the right fit, enter your vehicle’s year, make, and model in our built-in search function.
Are throttle cables universal?
In today’s modern vehicles, throttle cables are obsolete with the widespread use of drive-by-wire throttle pedal assemblies. Our universal throttle cable offerings fit most any application or engine type and mounting location.
Is my Harley Davidson throttle by wire?
Look at your handlebars. If there are two cables running down the handlebars it is cabled. If it doesn’t have any cables on the right side, it’s throttle by wire.
What causes a Harley to go into limp mode?
Limp Mode happens when there is a correlation error between the twist grip sensor, electronic control module, and throttle control actuator. It limits the RPMS and throttle response of the bike. Basically, it lets you limp the bike home or to a shop to get it repaired.
What does TBW mean on a Harley Davidson?
1. Your bike uses Harley-Davidson Throttle By Wire (TBW). 2. You would like to run Internal Wiring (All Makes).
Is throttle cable and accelerator cable the same?
Your car’s accelerator cable, also known as a throttle cable, is a braided metal wire that connects the gas pedal to the engine throttle plate.