Question: How To Adjust Rear Shocks On Harley Davidson Dyna?

How do I stiffen the rear shock on my motorcycle?

Rear shock preload To adjust the preload on your bike’s rear shock, you will need a C-spanner to loosen the top locking ring and spin it up the shock to gain access to the adjuster ring. If you want to increase preload so the spring has less travel and to make the bike feel stiffer, turn the adjuster ring clockwise.

How do I lower the shocks on my motorcycle?

Adjusting the rear shock preload is typically done by loosening a pinch bolt on the threaded collar at the top of the spring and turning the collar counterclockwise. Some bikes come with a preload adjuster dial that can be turned by hand. By reducing preload, you can lower the rear ride height.

How do I make my rear shocks stiffer?

One can get oil-based shock absorbers filled with higher viscosity oil (thick oil) that make the ride quite stiff. Or you could get new gas filled shock absorbers that also provide a slightly stiffer ride. There are race / rally based shock absorbing systems that will make the ride stiffer as well.

How do you adjust shocks on Hagon?

turning the bottom ring clockwise to the bottom of the shock will raise it, counter clockwise will lower it. I hope you didnt throw the tool away with the box With the adjuster at the bottom, hook the C spanner onto it from the right and pull it towards you.

You might be interested:  Quick Answer: How To Fix Sticky Rear Caliper On 2003 Harley Davidson Electra Glide?

How do I adjust my shocks?

7 Steps To Finding Your Perfect Shock Setting

  1. Set bump and rebound full soft.
  2. Do an out and in lap.
  3. Add bump in two click increments until the “feel” of steering improves, doing an out and in lap with each adjustment.
  4. Now add rebound in two sweep (or click) increments until car “feel” (driver confidence) improves.

Does adjusting preload change ride height?

The suspension may feel stiffer when preload is increased, but that’s because adding preload compresses the spring, so it takes more pressure to move the suspension any further. Adjusting preload simply determines the motorcycle’s ride height. Basically, when ride height is overly high there is too little sag.

How do you measure motorcycle rear shocks?

The eye-to-eye measurement is the length of the shock from the centre of one mounting eye to the centre of the other. Also remember to measure the size of the connecting hardware, including the width of the end bushings and the size of the bolts used to attach shock to frame (normally 5mm or 7mm).

How are Harley shocks measured?

Harley Fanatic If you want to know what your shock lengths are now, put the bike on a bike lift and let the rear wheel hang in the air. Now measure the distance between the shock lower and upper eyes centerline to centerline. This should be close.

Leave a Reply

Your email address will not be published. Required fields are marked *