Question: How To Change Fork Oil On A 2004 Harley Davidson Road King Video?

Can you change fork oil without removing forks?

You will need to remove the caps to refill the fork tubes with oil. Determine if the fork legs have oil drain plugs near the bottom of the legs. If they do, you are in luck and will be able to change the oil without removing the fork legs.

How much oil does a Harley fork take?

Replace the plugs and fill the forks through the top caps with an approved fork oil. The capacity varies by model but for most Softails and Dynas this amount is about 9 to 10 oz. If using Harley brand fork oil then type “B” or “E” is recommended depending on the model.

How often should you change fork oil on a Harley?

Damping helps with how well your bike adheres to and is affected by bumps in the road or unevenness. How often should you change your fork oil? That is a very good question. It’s been quoted as every year, every two years, every 30,000 miles, every 50,000 miles and more.

You might be interested:  Often asked: What Motor Is In 2004 Harley Davidson Road King Classic?

How much fork oil do I need?

You can remove the compression unit using a 32mm nut or a 19mm open end wrench. After removing the compression unit you will find a chamber filled with oil. It’s about 200ml of oil.

How often should you change your fork oil?

The oil in your fork loses lubricity, gets dirty, and should be changed every 10,000 miles or once a year.

Does changing fork oil make a difference?

A change in viscosity by just a couple of points makes a big difference in suspension compliance and action. All that applies to the fork also pertains to the shock (or shocks). The piston wears on the shock body, picking up metal that then travels through the oil and damping circuit.

Can I change fork seals without disassembly?

Yes. Pull the bolt out that secures the cartridge to the lower fork leg and the forks will come apart. Put a seal in with a split type fork seal driver. Then you pull the cap and separate from cartridge to pull the spring to set the fork oil level.

What kind of oil goes in Harley primary?

You actually have a couple of choices for the primary drive. The optimum product would be Mobil 1 Racing™ 4T 10W-40 motorcycle oil, but it is also okay to use Mobil 1™ V-Twin 20W-50.

How much oil goes in a Harley primary?

Fill the primary with oil Harley Davidson Softails require one quart of primary fluid. Be sure to check your owner’s manual or the AMSOIL Product Guide for the correct primary oil capacity for your bike.

You might be interested:  Question: Who Created Harley Davidson?

How often should you change primary oil in my Harley?

Oil changes as per Owners manual every 5k Miles, Tranny and Primary every 10K. If you ride it more you’ll be changing it more often.

What kind of oil goes in Harley Forks?

Spectro Performance Oils R. HDFOE Heavy Duty Fork Oil ( Type E SAE 20, 1 Quart)

What does heavier fork oil do?

And yes, heavier weight for oil will definitely help. It’s an easy and cheap way to stiffen forks. It will make them less supple for small bumps, but it’s fairly easy to swap the oils until you find a weight that is decent for jumps and decent for the trails.

What weight is Harley fork oil Type E?

According to the Amsoil sites, Harley Type E oil is 10 wt.

Leave a Reply

Your email address will not be published. Required fields are marked *