Question: How To Replace Starter 1989 Harley Davidson Fxrs?
- 1 How do I know if my Harley starter is bad?
- 2 Where is the starter on a Harley?
- 3 How do you test a starter solenoid on a Harley?
- 4 Why does my Harley start clicking?
- 5 How do you tell if your starter relay is bad on a motorcycle?
- 6 What are the symptoms of a bad starter solenoid?
- 7 Can you bypass a starter solenoid?
- 8 How do you test a Harley ignition switch?
- 9 What does it mean when starter relay clicks?
- 10 What causes a motorcycle not to start?
How do I know if my Harley starter is bad?
Symptoms of a bad motorcycle starter may include the motorcycle not being able to start at all, the motorcycle only starting intermittently, hearing the starter running even when the engine has already started, and being able to hear a strange clicking sound from the starter.
Where is the starter on a Harley?
Check the visual condition of the starter and the starter solenoid, located on the right side of the engine behind the rear cylinder. Specifically look for loose wiring connections or damaged wiring.
How do you test a starter solenoid on a Harley?
PUSH TEST: Run a second ground lead from the battery negative terminal to the solenoid post. Then, run a lead from the starter contact (where the green trigger wire from your start button plugs into) and connect the opposite end to the battery positive post. *The starter shaft should PUSH out.
Why does my Harley start clicking?
When you turn the key and the battery is dead, you hear the magnet trying to magnetize the gear which is what makes the clicking sound. If the battery doesn’t give enough power, that magnet doesn’t have enough power to turn the flywheel of the engine.
How do you tell if your starter relay is bad on a motorcycle?
Secure red jumper wire from the positive battery post to the yellow or red wire terminal on the starter relay. Listen for a clicking sound. This sound is the contact inside the starter relay. If you do not hear a click, the starter might be malfunctioning.
What are the symptoms of a bad starter solenoid?
Consider these possible signs of a failing or bad starter solenoid when you turn the key:
- Nothing happens.
- A single “click” sound comes from the engine compartment or from under the car.
- Repeated “clicking” sounds usually indicate a dead battery.
Can you bypass a starter solenoid?
Place the metal blade of an insulated screwdriver across both metal contacts. This bypasses the solenoid and creates a direct connection between the starter motor and the ignition switch.
How do you test a Harley ignition switch?
Remove the dash and turn it upside down and take a look at the switch. Is the harness plugged into the switch? it’s a 3 wire connector. Test for voltage at the red wire, it should read battery volts.
What does it mean when starter relay clicks?
4. Clicking sound coming from the starter. This symptom is common when your battery is low on amps, but is also an indicator that your starter relay is not sending a full signal. The relay is an all or nothing device, meaning that it either sends the full electrical current or sends nothing to the starter.
What causes a motorcycle not to start?
One potential issue that might be keeping your motorcycle from starting up is a clogged petcock. The petcock is a fuel control valve. It controls the gas flow between off, on, and reserve settings. Clogged petcocks are a common issue that riders often bring up in forums.