Question: What Type Of Oil Does 2010 Harley Davidson V Rod Muscle?

What oil does a VROD use?

Put in 5 quarts or 4.3 litres of 20W-50 full or semi-synthetic motor oil made specifically for motorcycles.

What oil does Harley Davidson recommend?

Ans: For all weather conditions, Harley Davidson recommends SAE 20W50 synthetic oils the Twin Cam engine. But if you live in a region where it gets below 40F, you should get something that maintains SAE 10W40 standards. Similarly, SAE 60 H-D is suggested for higher temperatures above 80 degrees.

What weight oil do I use in my Harley transmission?

Our answer: It is perfectly acceptable to use 75W-140 gear oil in Harley-Davidson transmissions. But, do consider that 75W-140 is much thicker than oils typically used in Harley transmissions. For instance, AMSOIL V-Twin Synthetic Transmission Oil is an SAE 110 gear oil.

Is synthetic oil better for my Harley?

Synthetic oil is preferable to mineral oil primarily because it has a higher heat tolerance. That is very important in air-cooled engines like the one in your Harley. Not all synthetic oils are the same.

Can I use car oil in my Harley-Davidson?

Can I use car oil in my Harley? If the oil is of good quality, then you can use it on your Harley. However, the oil should be SJ rated as it may end up destroying the roller bearings. The best oil to use on your bike should be labeled as motorcycle oil.

You might be interested:  FAQ: Harley Davidson What Is The Turn Front Signal L Wire Codes?

How often should you change primary oil in my Harley?

Oil changes as per Owners manual every 5k Miles, Tranny and Primary every 10K. If you ride it more you’ll be changing it more often.

How much oil goes in a Harley-Davidson primary?

Fill the primary with oil Harley Davidson Softails require one quart of primary fluid.

Can you use synthetic oil in Harley primary?

Answer: For any Harley Twin-Cam engine, we highly recommend using AMSOIL Synthetic 20W-50 in “all three holes” (as they put it) for two essential reasons. These are called AMSOIL V-Twin Primary Oil and AMSOIL V-Twin Transmission Oil.

Can I use 75w90 in my Harley transmission?

It’s a synthetic gear oil. It will be just fine in the trans. I would recommend using gear oil in there over motor oil.

How do you check the oil on a Harley Davidson V Rod?

Check the oil level with the engine at normal operating temperature as follows:

  1. Stop the engine and allow the oil to drain into the sump for about two minutes.
  2. Stand the motorcycle upright (not leaning on the jiffy stand) on a level surface.
  3. See Dipstick Location: VRSCDX.
  4. Screw the filler cap into the engine.

Leave a Reply

Your email address will not be published. Required fields are marked *