Question: Where Is The Oil Drain Plug Located On A 2003 Harley Davidson Wide Glide?

Where is the drain plug on a 2003 Harley Davidson?

The drain plug is located under the round derby cover on the primary. Place your oil catch pan below the plug and drain the primary fluid completely. Clean the drain plug replace the O-ring before reinstalling the plug onto the primary housing.

Where is the oil drain plug on a Harley?

Look directly below the seat– and slightly behind it – underneath the frame to find the oil drain plug. Use a ratchet and 5/8-inch socket to remove the drain plug. Once loose, finish removing the plug by hand to avoid dropping it into the oil pan.

Where is the oil drain plug located?

The drain plug is a large nut or plug located under the oil pan at the bottom of the engine. If you can’t reach your oil drain plug easily, you’ll have to either crawl under your car to reach it or jack up the car.

You might be interested:  Question: How To Get A Harley Davidson Rise Out?

How much oil does a 2003 Harley Davidson Ultra Classic?

Fill the oil tank with three quarts of 20W-50 motor oil, and the transmission with one quart of Harley-Davidson transmission oil.

How much oil goes in a Harley primary?

Fill the primary with oil Harley Davidson Softails require one quart of primary fluid. Be sure to check your owner’s manual or the AMSOIL Product Guide for the correct primary oil capacity for your bike.

What kind of fluid goes in a Harley primary?

You actually have a couple of choices for the primary drive. The optimum product would be Mobil 1 Racing™ 4T 10W-40 motorcycle oil, but it is also okay to use Mobil 1™ V-Twin 20W-50.

How much oil goes in a Harley transmission?

The transmission fluid capacity is approximately 24 ounces (0.71 liters).

How often do you change the primary oil in a Harley?

Oil changes as per Owners manual every 5k Miles, Tranny and Primary every 10K. If you ride it more you’ll be changing it more often.

Do you check Harley oil on kickstand?

The transmission oil is checked with the motorcycle on a level surface and on the kickstand. The transmission oil level is correct when between the Add and Full marks on the dipstick.

How much oil goes in a Harley 103?

Start the drain plug into the oil pan by hand. Snug it; and final tighten to 14 – 21 foot lbs. Now, remove your fill plug and pour 3 full quarts into the fill allocation. This is, now, a sufficient amount of oil to check your oil level.

You might be interested:  Often asked: Where Is The Original Harley Davidson Factory?

Is changing oil easy?

It’s a simple process that requires few tools, and it’s a sure way to save some money while you avoid the hassle of sitting in a dull waiting room somewhere reading outdated magazines. More than anything, the basic oil change is a great way to connect with your vehicle and take some control over its maintenance.

How much does an oil drain plug cost?

The general range is between $100 and $350, but there are some vehicles that cost more. You can get an oil pan gasket replacement for between $40 and $150. The part is not the most expensive part of the repair, but the labor can be very intensive.

What does an oil plug look like?

Look at the bottom of the engine oil pan. Around the bottom of the pan, you should see a single bolt. That’s your oil drain plug. (Some vehicle models use a similar round plug, which you can pull to drain the oil.)

Leave a Reply

Your email address will not be published. Required fields are marked *