Readers ask: How To Identify Trouble Codes For Harley Davidson Street Glide?

What is the red key light on my Harley?

The red “key” light is telling you that the security system is operational. The fact that it goes out after you start it up means that the security system is disarmed.

What does low RNG mean on Harley?

“LO RNG” to indicate that the motorcycle will shortly run out of fuel. When the low fuel warning lamp turns on, the fuel level is low. Refuel as soon as possible. The range display is only updated when the vehicle is moving. The automatic fuel range display is enabled after the ignition is turned OFF IGN.

How do I reset my Harley ECM?

Harley Davidson Touring: How to Reset Your ECM

  1. Step 1 – Turn run switch on. Before you start the reset procedure, be sure your run/stop switch is turned on.
  2. Step 2 – Turn ignition on and off. With the run/stop switch on, turn the ignition on and then off three times.
  3. Step 3 – Turn run switch off.

What is the default Harley security code?

By Bikers For Bikers. VIDEO-If your Harley Davidson is equipped with a factory installed alarm then you really need to immediately change your security PIN code. Harley puts a standard factory preset PIN code and it is usually 31313.

You might be interested:  Question: Who Makes Harley Davidson Boots?

What is a Tssm?

Acronym. Definition. TSSM. Two-Spotted Spider Mite.

What is a ECM on a Harley?

Flashing the ECU / ECM – Your Engine Control Unit (ECU) also referred to as the Engine Control Module (ECM) is the computer that controls key functions related to your engines performance such as your Air / Fuel Ratio (A/F), variable valve timing, etc.

Can you run diagnostics on a motorcycle?

If your bike has an onboard computer, it has a diagnostic port to check for potential problems. And if it does have an OBD-II port, you can easily access it with computer software or a wireless dongle and an app, RevZilla reports.

Can you use an OBD2 Scanner on a motorcycle?

Some motorcycle brands like Harley Davidson have implemented on-board diagnostics across all their models for many years now. And, like on cars, Harley OBD systems also use the CAN protocol, which means any regular OBD2 scanner will work well with them.

How do you check V Rod codes?

5- to get DTC within an area, you push and hold the button in for 5 seconds and if there are any, it will be displayed you can release the button. As you push the button again, other codes will appear if they are there.

Leave a Reply

Your email address will not be published. Required fields are marked *