Readers ask: How To Test A Harley Davidson 1986 Hitachi Starter?

How do I know if my Harley starter is bad?

Symptoms of a bad motorcycle starter may include the motorcycle not being able to start at all, the motorcycle only starting intermittently, hearing the starter running even when the engine has already started, and being able to hear a strange clicking sound from the starter.

What are the symptoms of a bad starter solenoid?

Consider these possible signs of a failing or bad starter solenoid when you turn the key:

  • Nothing happens.
  • A single “click” sound comes from the engine compartment or from under the car.
  • Repeated “clicking” sounds usually indicate a dead battery.

How do you tell if your starter relay is bad on a motorcycle?

Secure red jumper wire from the positive battery post to the yellow or red wire terminal on the starter relay. Listen for a clicking sound. This sound is the contact inside the starter relay. If you do not hear a click, the starter might be malfunctioning.

You might be interested:  FAQ: Where Can I Buy Where Can I Buy Harley-davidson Primary Oil And 14609?

When I try to start my motorcycle it just clicks?

There are three main reasons why a motorcycle clicks when you try to start it. The first and most common reason is because of a dead battery. The second reason could be due to a bad starter. The third most common but less likely reason the motorcycle is clicking could be due to a seized engine.

What could cause a motorcycle not to start?

Most of the time if your bike will not start it is something as simple as making sure the fuel control valve is not clogged with rust; making sure corrosion has not built up within the valve itself causing dry rot, cracking, or leaking.

How do you check the ohms on a starter?

To check the voltage reaching the starter, connect one lead of the voltmeter to the solenoid feed terminal and the other to the starter casing. To check for a high resistance between the battery and starter, connect the voltmeter between the battery feed terminal and the starter.

How do you check a relay to see if it’s bad?

The only tool required to check a relay is a multimeter. With the relay removed from the fuse box, the multimeter set to measure DC voltage and the switch in the cab activated, first check to see if there are 12 volts at the 85 position in the fuse box where the relay plugs in (or wherever the relay is located).

What does it mean when starter relay clicks?

4. Clicking sound coming from the starter. This symptom is common when your battery is low on amps, but is also an indicator that your starter relay is not sending a full signal. The relay is an all or nothing device, meaning that it either sends the full electrical current or sends nothing to the starter.

You might be interested:  FAQ: What Years Did Honda Own Harley Davidson?

What does a starter relay do on a Harley?

The starter relay in a motorcycle enables power to flow from the battery to the motor when you start your motorcycle.

Can you bypass a starter solenoid?

Place the metal blade of an insulated screwdriver across both metal contacts. This bypasses the solenoid and creates a direct connection between the starter motor and the ignition switch.

How can I test my starter without removing it?

The easiest way to check the starter on the vehicle is to use jumper cables to bypass the vehicle’s electrical system. With the ignition turned off and the transmission in “park” — and with all due care — connect one end of the red/positive jumper cable to the positive terminal of the battery.

How do I test a starter solenoid?

Have a friend turn the key in the ignition to attempt to start the vehicle. Listen carefully, as you should hear a click when the starter solenoid engages. If you do not hear a click, the starter solenoid is likely not functioning properly. If you do hear clicking, the solenoid may be engaging, but not sufficiently.

Leave a Reply

Your email address will not be published. Required fields are marked *