FAQ: How To Change Oil On 2008 Yamaha R1?
How do you change the oil on a Yamaha R1?
How to Change the Oil in a Yamaha YZF R1
- Position a drain pan under the engine and remove the oil filler cap from the right side of the crankcase.
- Remove the 8mm Allen drain bolt and crush washer from the bottom of the engine, and let the oil fully drain out.
What oil does a 2008 Yamaha R1 take?
2007-2008 Yamaha R1 4th Gen specification. Yamaha recommends using their own motor oil, which is affordable and good. Yamalube 10W-50 covers a huge range of operating temperatures, from below freezing to above 100 degrees F / 40 degrees C. Replace every 2nd oil change.
What type of oil does a 2007 Yamaha R1 take?
YAMAHA Sport II Motorcycle AP SAE 10W40 Oil Change Kit 2007-2013 YZF-R1 / 2006-2013 YZF-R6 LUB-SPTCG-KT-15.
How much oil does a 2008 Yamaha R1 take?
The R1 will use just under 4 quarts of oil, so don’t overfill. Wipe up any spills and start up the bike. While the bike is running, slowly loosen the oil filter until a small amount of oil begins to escape from the space between the filter and the engine, then tighten again.
How much oil does a 1999 R1 take?
Officially it’s 3.2 liters, but just drain it, remove the filter and let it drain some more. Put the plug in and install a new filter and fill it with ~ 2.9 liters. Start it and let it get to operating temp. Let it cool.
How do you check the oil on a 2020 R1?
Turn bike off, wait a few minutes, and check oil. Should be in top half between two lines on sight glass with bike straight up, and level on both wheels. (not on side stand) If rear is on stand, the bike will pitch forward, and it will show less oil in sight glass than is actually in the bike.
What oil does a 2002 Yamaha R1 take?
AMSOIL synthetic lubricants are the solution for riders who want the most from their 2002 Yamaha YZF-R1. They resist the devastating effects of extreme heat, even in rally or parade traffic on hot days.